Tags

A few days ago I fitted the Black Vue DR650S-2CH 16GB twin camera dash cam to the Amarok. All in all it was a vey easy install taking me less than two hours to accomplish. The longest part was actually tucking the wires in along the edge of the head liner so they can’t be seen. Helpfully Black View supply a little blue tool that helps you do this without damaging any of the interior trim. I also installed the Black Vue Power Magic PRO that allows permanent connection to the vehicles electrical system and gives you the ability to use “Parking Mode” which records continuously when you are parked with the engine off.

If you have considered a dash-cam but don’t know where to start, one of the best introductory guides to Dash Cams that I have seen is by Techmoan.com. Just click on the link to watch it. There are also dozens of dash-cam reviews on His channel.

The electrical side of add the camera was made easy by using “Add A Circuit” fuse holders. (I’ve put links to everything on Amazon at the bottom of the post) Crimp the Add A Circuit on to the correct cable on the Power Magic unit then simply identify which circuit is permanently live in the fuse box, select a fuse, pull it out and insert it into the Add A Circuit fuse holder along with a fuse of the correct rating for the Power Magic and push the Add A Circuit into the space where you removed the fuse from. You will need two as the Power Magic requires a permanent 12 volt supply and an ignition switched 12 volt supply…. and a ground of course.

From the driving position very little of the front camera can be seen.

There are several switches on the Power Magic to set before you install. The first set the minimum voltage the unit will turn the cameras off at, this stops you flattening the vehicle starter battery, the second set sets a time for the cameras to stop recording after 24 hours, 48 hours or you can set it to infinity. There are several combinations and it’s all explained in the instructions.

The rear camera is installed at the top of the window avoiding getting one of the heating elements in view.

A few installation tips….

Try to install the camera so that the lens is as central as possible so you capture as much of the road as possible.
Try to install the front camera so that the area in front of the camera is swept by the windscreen wipers so you can clear the rain.
If you install a rear view camera, try to make sure it is not positioned directly in view of one of the heating elements, but close enough so that the window is cleared when the screen heater is on.